Setup Guide
Wiring Guide
Connect Ranger to your Control Hub / Expansion Hub with a 4-pin JST-PH to 4-pin JST-PH cable.
Connect Ranger to an Analog port if you will be using 15°/20°/27° modes.
Connect Ranger to a Digital port if you will be using DETECT mode.
Configuring Ranger
There are two switches on Ranger. These two switches are used to determine which mode Ranger is in.
The mode is locked once Ranger is powered on, if you need to change the mode, disconnect power, change the mode, then reconnect power.
Below is a table of switch states and their corresponding mode, this information is also listed on the case:
Left Switch State | Right Switch State | Mode Selected |
---|---|---|
0 | 0 | 20° FOV Mode |
0 | 1 | 15° FOV Mode |
1 | 0 | 27° FOV Mode |
1 | 1 | DETECT Mode |
Last updated